Star-LT17 series
17 inch Veterinarian wireless X-ray detector
Star-LT17 series detectors feature a specialized antenna design maximizing the bandwidth that 802.11ac allows, which results in raw image transfer speeds within two seconds. This design also increases signal strength allowing the systems to be used anytime, anywhere.
Smart design for Hot swap and seizing image in time
Featherweight design
To enhance the mobility, the whole device weighs only 4.9kg including the battery, making it effortless to carry around.
The detector is IPX6-rated for fluid infiltration, allowing user to clean it easily.
Self management and monitoring
All detectors are equipped with an array of sensors(Temperature sensor, Humidity sensor, Air Pressure sensor, G-sensor, Angle sensor), such as temperature, gravity (and many more). These operate even while the panel is powered off to ensure that the detector is functioning properly and safe to use by the staff.
Remarkable long-lasting feature
Star-LT17 series batteries yield over 8 hours of operating time while capturing more than 1,000 images every 30 seconds sequentially without interruption.
Access point mode
Star-LT17 series wireless system has the capability to operate in access mode, when the environment calls for a direct sensor to computer wireless connection.
Overview
Specification
| Dimension (ISO 4090) | 460 x 460 x 15 mm |
| Sensor array | a-Si photodiode |
| Scintillator | Csl / GOS |
| Resolution | 3072 x3072 |
| Pixel size | 140 um |
| Grayscale | 16 bit |
| Wifi | 802.11ac / 2 antennas / 2s scan to display / AP mode |
| Drop height | 70 cm |
| Housing material | Mg-Al alloy |
| Weight (battery included) | 4.9 kg |
| Waterproof | IPX6 |
| Durability (Face load / Point load) | 300 / 120kg |
| Battery autonomy | 8 hours * |
| Trigger mode | AED mode |
| Log file | Log file, sensor data and other calibration data are available |
| Accessories | Battery / Magnetic connector cable with ethernet and power |
| Operation temperature / Humidity | 10 ~ 35 °C / 15 ~ 80% |
*In SYNC mode, user can capture more than 1,000 images at every 30 seconds and lasting over 8 hours.
*The specifications described above are based on a full battery charge and may vary depending on system configuration and environment.
